-
Im getting closer to building my BBC. I got my block in today. Its a Gen VI 454 block. So far i have block, intake, exhaust, roller lifters, timing cover, lifter retainers and the dogbones that hold the lifters in place. Are the stock hyd roller lifters ok for 500-600 hp?
-
Depends on the lift......
-
Does a Gen VI use the same motor mounts as a Gen IV. I may get a rail kit.
-
Motor plates are the same for MK IV and a Gen VI. I have a some parts for sale for a Gen VI motor as follows:
1. Used motor plates
2. Used Callies Magnum Plus 4340 forged crankshaft with a 4.375 stroke one piece rear seal
3. Stef's 13 quart aluminum oil pan for a Gen VI with oil pump and pickup
If interested, PM me.
-
taylorman if you can go with a rail kit if you need to side the motor up are back it's alot easy
-
Watch out for the peanut-port heads that came on trucks. Smallest port I've ever seem - smaller than "oval" ports - almost round. They seem to be real common. They say these heads are good for low rpm torque, but suffer when it comes to high rpm hp.
-
Taylor man, NO on the lifters. If you check your GM HP catalog, you'll see that they use a different part number lifter for the performance engines. I learned this the hard way.