Search:

Type: Posts; User: GN107

Search: Search took 0.00 seconds; generated 50 minute(s) ago.

  1. Replies
    1
    Views
    6,784

    Measure between the transom and rear motor mount....

    Measure between the transom and rear motor mount. If it is under 36", start moving the motor forward in 1/2" increments until you get the desired ride
  2. Replies
    3
    Views
    33,963

    Putting a small shaft into the V-Drive coupler...

    Putting a small shaft into the V-Drive coupler letting it hang out. Pull the prop shaft up to the small shaft. Now use a six inch straight edge to see if they are in alignment in all directions. This...
  3. Sounds like a great event

    Sounds like a great event
  4. Thats a good price! Good Luck withe the sale

    Thats a good price!

    Good Luck withe the sale
  5. Replies
    2
    Views
    6,626

    That think looks sweet!

    That think looks sweet!
  6. Replies
    0
    Views
    4,225

    2001 Howard 22' Bowrider

    For Sale: 2001 Howard 22' Bowrider $30,000.00

    Very clean and well maintained boat. Only 255 hours

    496 MAG Mercruiser with Bravo 1 Drive
    Stainless Steel three blade propeller
    Large foot...
  7. Replies
    0
    Views
    21,367

    454 Chevy Exhaust Manifolds

    I have a set of Glenwood Polished Exhaust manifolds and risers for sale off of my boat. They will fit any big block chevy.
    I bought them brand new and used one time. Then put Stainless Steel exhaust...
  8. Replies
    6
    Views
    6,836

    I would recomend leaving the engines in there...

    I would recomend leaving the engines in there currant rotation. Too much to change to turn one engine around. Plumbing, Mounts, bell housings, drives, props, the list goes on and on. Work with the...
  9. Replies
    1
    Views
    6,248

    I have never seen a Stevens Tunnel, could you...

    I have never seen a Stevens Tunnel, could you post some pictures
Results 1 to 9 of 9