Hi,
I just bought a hydrolic place diverter for $325. It came with the actual place diverter and a hydrolic pump. I don't know if the pump works, but it seems to be used only a couple of time based on the condition of the wear on the teflon rings. The guy said he wanted a droop so he took this one off. My question is this: There might be a couple of nuts and bolts missing from the diverter. Where can I get a diagram? Also the diverter is missing the hydrolyc cylinder. Where can I buy this part. Basically does any one know a source where I can buy replacement pump for Place Hydrolic Diverters? Also can any one tell me how to install it. Such as whether or not to cut holes in the transom for the tubes and what kind of water proof sealant to use on these holes?
Thank You very much everybody for your previous help,
Dennis
you should be able to get the parts from REX (thats where I bought my diverter) I drilled two small holes just big enought to fit the tubes through then used the 3m marine silicone around them. I drilled the hols below my swimstep, which is below the water line when not moving. So far no leaks
I just found that the mounting plate for the hydrolic pump is missing. Also what is the upper arm on the nozzle for?
give em' a call. I'm sure they can help you. http://www.placediverter.com/
These are the guys that build em
http://www.bennetttrimtabs.com/
They have a replacement parts page and are quite helpful
Posting Permissions
Reply With Quote