Results 1 to 7 of 7

Thread: HEI distributer blocking ski tow

  1. #1
    Screemy1
    How do you mount the ski tow on the engine with an HEI distributer in the way?http://www.***boat.com/image_center/...66boat0004.jpg

  2. #2
    lucky

    no seriouly - can ya get a better pic of the clearence problem - if it is on the side - and you just need a little ( little being the key ) spread it - you will have to be the eyes here as i can not see your situation - hyd jacks work will - porta powers - two buddy's with chain and four wheel drives ( ok the last one is a joke ) :eek!: if all bolt holes are facing the same direction - put spacers and longer bolts to raise the whole thing - if all else fails - cut and weld - orrrrrrr visit rex marine and get a transom mount . I like the block mounts better those are my not seeing it options and this is just a general ! every application is different - just get drunk and stare at it - you will figure it out later chris

  3. #3
    Screemy1
    Clearence.... I have a DUI and would love to get rid of the old duel point mallory
    http://www.***boat.com/image_center/...geQuality=Full
    http://www.***boat.com/image_center/...geQuality=Full

  4. #4
    JET-O-VATOR
    Mine Fits Fine W/ The Heithere Spacers From The Tow To The Heads....

  5. #5
    Challenged Pimp
    Hmm, Fords don't have that problem :wink:

  6. #6
    1978 Rogers
    I don't have that problem on my 460 either. I think you have a bad engin.

  7. #7
    Bryan Rose
    How do you mount the ski tow on the engine with an HEI distributer in the way?http://www.***boat.com/image_center/...66boat0004.jpg
    Looks to me like wher you are putting it is in the wrong place... Kind of hard to tell by the pictures... It should come off the two top bolts on the bell housing ( for the lower mounts ) and the top mountsd should go into the bossed hole on each head in the back....this ski tow mounts on the block and heads in a vertical relation... in other words it goes on the back of the block and heads , not the top of the block and heads.Get it?http://www.***boat.com/image_center/...C01502-med.JPG

Similar Threads

  1. distributer and condensor
    By LAFD in forum Sandbar
    Replies: 1
    Last Post: 08-30-2006, 12:58 PM
  2. Telemarket - Blocking
    By Willis in forum Gear Heads
    Replies: 0
    Last Post: 01-30-2006, 09:16 AM
  3. MSD Distributer ID
    By bocco in forum Gear Heads
    Replies: 2
    Last Post: 11-17-2005, 09:46 AM
  4. what kind of distributer
    By hoolign in forum Gear Heads
    Replies: 6
    Last Post: 05-17-2003, 09:17 PM
  5. Oil coming out distributer....
    By 78Eliminator in forum Gear Heads
    Replies: 17
    Last Post: 09-04-2002, 05:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •