We just bought a boat with an 502EFI and a Bravo1. On the dash it says that it has an alarm and to test it all I have to do is turn the key to the on position while the motor is off. Well I did that and the alarm didn't go off. Does anyone have any ideas why this wouldn't work? I was going to post this in the outdrive section but as most of you know it doesn't get much traffic.
FWIW, ours takes about 10sec from key on with no motor to start the alarm. Then it is a very annoying alarm.
Apparantly it is designed to raise the operator's stress level when the boat isn't started immediately. :hammer2: