I had the same problem. I ended up painting mine with the bucket still attached :rollside: good luck!
I am getting ready to take my diverter,droop and wedge to get "jethotcoated" but I cant get the damn reverse bucket off. My reverse bucket pins ont go all the way through.On a stock nozzle the pins can be pushed through. This place diverter cant. What do I do?
396
I had the same problem. I ended up painting mine with the bucket still attached :rollside: good luck!
I got it off. You have to pound the shit out of it untill the pin backs out a little, then grab the pin with vise grips. Pull while turning left and right. i called place diverter
396
Somebody had a trick for that. It was quite a while ago, but it's out there somewhere.
Somebody had a trick for that. It was quite a while ago, but it's out there somewhere.
Yeah, it's called get a bigger hammer that the one that wasn't doing the job. :hammer2:
If I had the time I would have drilled the pin, tapped it, and made a slide hammer to yank it out. Who has time though?
I got it off. You have to pound the shit out of it untill the pin backs out a little, then grab the pin with vise grips. Pull while turning left and right. i called place diverter
Yup, that was it.