I'll give ya $20
How ya been Tony?
4.250 Crower Billet crankshaft $1200. No cracks
PM if interested
I'll give ya $20
How ya been Tony?
Hey Joe!
How goes it?
4.250 Crower Billet crankshaft $1200. No cracks
PM if interestedNot being much of gear head I have to ask...I'm building a 351 Ford Windsor engine, will this work in my application???. If so i'll take it. Nothing but "BILLET" for guy. :supp:
Hey Guru will this crankshaft by chance fit in my 1945 vintage Desoto engine. If so you have a deal. I think it would be cool.
Not being much of gear head I have to ask...I'm building a 351 Ford Windsor engine, will this work in my application???. If so i'll take it. Nothing but "BILLET" for guy. :supp: I'm sure that it will! It just needs a little adjustment on the journels send it up, I just got a new Makita 4.5 inch grinder! :2purples:
Yes it will fit all of these applications. In fact You Te called and asked if it will fit in ass again!!! Same response to him!
Yes it will fit all of these applications. In fact You Te called and asked if it will fit in ass again!!! Same response to him!
LMFAO
http://dmontzmax.maximaclubca.com/Si...ies/rockon.gif
JBG. Check your PM's, see you at MING with some $$$.
I'll give ya $20
How ya been Tony?
Tony I will 2 X that $40