Need help

[canuck1]

I would like to put a smaller blower on the tub like a weiand(sp) or something similar but the problem I have is that I have about an inch of space in front of the crank pulley(2 row). Can I run off the lower pulley? or do I not have enough room? any ideas or other options

[blown428fe]

From the front of my motor plate to the pully bolts is 4-5/8 inches including alt. pully with 1-1/2"s to the seat. Dont know if this will help you.

[bottom feeder]

I would like to put a smaller blower on the tub like a weiand(sp) or something similar but the problem I have is that I have about an inch of space in front of the crank pulley(2 row). Can I run off the lower pulley? or do I not have enough room? any ideas or other options
Yes you need help! your looking at the wrong end! LOL you could drive it from the flywheel side. Drop me a line I have a compleate procharger get up that mounts on the back of the motor.

[coolchange]

From the water pump boss on a SBC you will have a min of 7'' to the belt on a Weiand. Don't think they make different lenght snouts.