i used to strech the spring out in the t-fitting. more pressure on the check ball slows the water down. or, washers in there to increase spring pressure will work good as well.
took new /first jet boat out ,getting water out of #2 weep hole while cruzing above 2500rpm tried lowering press ,now 8 psi ,switching lines,nozzels,ck'd bassett tee valve ran out of ideas,need help thanks
i used to strech the spring out in the t-fitting. more pressure on the check ball slows the water down. or, washers in there to increase spring pressure will work good as well.
Ditto. Try A new spring. I had the same problem when I bought my boat.
thanks i'll try that, hope that's all it is
Does it still come out of the weep holes at higher rpm. Does the engine run well? Hope you don't have a bad cylinder.
Brian
your right 25psi compression on #2 not enough to blow water out header. guess i'll take it apart pretty sure it's rings/piston , compression went up with oil in squirted in it..