Not the best but it does work.
can you use a rect port man on oval heads?
someone said no problemo if you use oval gaskets.
Not the best but it does work.
Not the best but it does work.
hard to get a good seal?
or just for flow?
I did it and it worked great BUT you need to blend the ports and you have to be careful, it's real easy to break thru the casting it's thin on the top, just blend the minimum and you'll be ok!..
hard to get a good seal?
or just for flow?
No problem sealing, just remember it's not square port heads!.
No problem sealing, just remember it's not square port heads!.
thats not even the worst part about the problem. i am going to be using a square port tunnel ram with square port spacers on a talldeck with oval heads.
this should be interesting.
and switching heads is not an option?
and switching heads is not an option?
looking for some but cant find any i can afford right now.
i figure ill just run it like that for this season.
Long Beach swap meet! Next one is May 8
Last time(4/10) I saw a few set's ,some of them fully prep'd or assembled
in the 500.00 range from dealers/regulars at swapmeet.Not sombody you will never see again. Just an F.Y.I.
Long Beach swap meet! Next one is May 8
Last time(4/10) I saw a few set's ,some of them fully prep'd or assembled
in the 500.00 range from dealers/regulars at swapmeet.Not sombody you will never see again. Just an F.Y.I.
thank you! i was thinking about going to pamona sunday.