Those motors are "Bad-Ass" Dan, and should sell fast !!
Just dynoed 900hp, 540's, new Edelbrock race heads ported by Morgan, Inconnel exhaust valves, roller cams, ext. oil pumps, new 1050 carbs, Superchillers, Stelling exhaust, MSD, new starters and water pumps, with all receipts, built by GT Performance and by B&D Marine......they run great, I just stepped up to a new boat ($55K for both) email: smokinbacon@aol.com
thanks for the spam!
http://www2.***boat.com/image_center...504/2595s_.jpg
Those motors are "Bad-Ass" Dan, and should sell fast !!
Those motors are "Bad-Ass" Dan, and should sell fast !!
THANKS!!! I hope so, could use the cash!
http://www2.***boat.com/image_center/data/504/2595S.jpg
ONLY 10 hours on both.....
Forget about the cash, let's go buy another smaller boat to toss these bad boys into and have some fun !! :jawdrop:
Not knowing much about blower motors, what fuel octane do you have to run on these and I assume that somewhat depends on whay pulleys and PSI ?
Not knowing much about blower motors, what fuel octane do you have to run on these and I assume that somewhat depends on whay pulleys and PSI ?
they are probably set up for 91
Forget about the cash, let's go buy another smaller boat to toss these bad boys into and have some fun !! :jawdrop:
Sounds fun, they'd be nice in a F29 :2purples:
you got the insurance?
they are probably set up for 91
ya, low boost and 91
currently 46 tooth top, and 51 bottom (dynoed with these)
fresh 8:71's, Imco gatlins incl. too
If I can figure out to place a classified ad, I'd get them outta here :hammerhea