Why did you get rid of the tunnel ram? Was it part of a compete motor that you sold? What type of 502 do you have? If it is just a GM crate 502/502 hp, I would get a demon or holley 850.
Any info on running a single carb 850/950/1050?Or a msd system or vertex mag? 502 cid. Im selling my tunell ram set up with the motor need to come up with another one.Whats good?
Why did you get rid of the tunnel ram? Was it part of a compete motor that you sold? What type of 502 do you have? If it is just a GM crate 502/502 hp, I would get a demon or holley 850.
Yes it was a complete motor. I know the entire set up works well. this way I only have to dial in one motor instead of two.Sold it to a friend.I started with the basic 440 horse 502,(same bottom end) and put on a set of edelbrock 6045 alum. heads so ill need everything to start over I have been looking at demons just was wondering if anyone else is running them?And i think it is a weind tunnel ram by the looks of it gonna call today. Was wondering what other people were runnig.The 454 set up worked extremly well.Anyone runnig a belt drive?
I run the 440hp 502 Mark VI crate motor as well. It has the cast rectangular port heads and aluminum intake that came with it. I run the Holley 850. It's a decent setup. That's about all the info I'm good for right now.
Good luck.
how bout a dart w/dom top??? serious grinding and epoxy, I had a vertex and traded it for the dart intake. replaced the mag with msd 85551 works much better the mag was a little lose needed rebuilt, besides I think mags like alky better.