I know this is the probably the wrong forum guys but bare with me. I was looking at some of the tech forums and there is not a whole lot of activity there sometimes. And my mechanic can't get to it before I head to the river next weekend. I need some advise on a trim gage. Yesterday i was out in my boat and I noticed that my trim gage isn't reading accurately. Once my outdrive is completely lowered the gage is telling me that it's only half lowered. I noticed this after planing out and wanting to trim up a little. I jumped in the water and checked it out. I found that I had a piece of wood lodged in the outdrive's travel range. Once I removed it the dial did exactly as before. The boat is still operating normal and I suspect that the actual gage is f'd. I just need to know if anyone else has experienced this type of thing. I need to know if I have a problem in the making a week before I go to the river. Any advice is appreciated.