Results 1 to 6 of 6

Thread: Alternator Pulley Removal 911

  1. #1
    Hallett19
    How can I get this pile of sh!t pulley off of here, there is no room to get anything in there, the other one was not nearly as hard to get off !!! I need to get this done today !!
    http://www2.***boat.com/image_center...128Picture.jpg

  2. #2
    Wicked Performance Boats
    1'2 inch ipact wrench will buzz it off! Budlight

  3. #3
    Tom Brown
    I second the vote for the impact.
    Also, it looks like the shaft will take a hex key so you might be able to hold it with that and use a box end wrench to turn the nut. The impact will be way easier, though.
    By the way, you can use a second combination wrench for more leverage by putting the box of the second wrench around the tine of the open end on the main wrench. Works slick. ... then, of course, you'll want a decent swing bar and a square drive hex key. Also, have some bandages standing by because you're knuckles are going to need them.

  4. #4
    Hallett19
    I dont have one of those in my 134 piece Craftsman hand tool kit.....

  5. #5
    Hallett19
    no way a box end will fit in there :notam:

  6. #6
    Wicked Performance Boats
    Find a buddy. You know, the one that goes to town and gets two blowjobs and comes back and gives you one. Budlight

Similar Threads

  1. Replies: 5
    Last Post: 09-18-2007, 09:19 AM
  2. Moroso Alternator pulley
    By wet77 in forum Parts 4 Sale
    Replies: 6
    Last Post: 03-23-2007, 05:00 AM
  3. Pulley removal
    By dtr352 in forum Gear Heads
    Replies: 2
    Last Post: 03-13-2006, 06:45 PM
  4. Circle boat alternator pulley needed
    By CircleJerk in forum V-Drives
    Replies: 4
    Last Post: 08-21-2003, 11:32 AM
  5. GM Alternator removal?
    By Tom Brown in forum Sandbar
    Replies: 15
    Last Post: 05-12-2003, 06:25 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •