SR,
Did you fill holes for the bump rail?
http://www.***boat.com/image_center/...anger_side.jpg
Still sanding, Sunday I should have this side and the deck done except the underside of the sponsons striped oh yea the 4x6 dog kennel is for sale cheap, anyone close need one? It will work for small dogs puppies or even chickens.
SR,
Did you fill holes for the bump rail?
There is no bump rail that is where they hooked the upper and lower halfs together
http://www.***boat.com/image_center/...tor_plates.jpg
Im in need of a short 2 peice drive line guard, you can see the measurements, the rear plate hole is approx 5.5" and will need the colar for the casal also, the one on it is to large. HELP HELP
http://www.***boat.com/image_center/...drive_line.jpg
Rich,
Give me a call.
Check my profile for the number
Dave
I also need a driveline guard for my sanger hydro.
No hardware, she is getting naked. Now how do I make the floor look great???????????????
http://www.***boat.com/image_center/...7floor-med.jpg http://www.***boat.com/image_center/...floor2-med.jpg
This is the worst part of the floor http://www.***boat.com/image_center/...floor3-med.jpg
Got belt sander, what grit is good for cutting down the resin and glass?? 80 grit?? Also I cant get those damn tanks out. Any realistic ideas, they seem to have been put in when when the resin was wet???????????????????
http://www.***boat.com/image_center/...7floor-med.jpg
use the coursest you can find & get with it..... If you want to get those tanks out, Cut those side deals off, pull the tanks out, install New ones or a T-Tank and install a turnbuckle from the stringers up to the side like this.........
http://www.***boat.com/hbcove/38/1/04.jpg