Jesus Christ!!!! What did you seal that pump with ....spackle!!!!!!
At the bushing/grommet, whatever that ****er is where the steering tube goes through the transom. Does anyone know where I can get one for. It's a berk JG if that matters.
Here's a little pic of the bastard
http://www2.***boat.com/image_center...36PDRM0001.JPG
Thanks in advance
Roland
Jesus Christ!!!! What did you seal that pump with ....spackle!!!!!!
The Jg Pump Has It's Clean Out On The Inside, I Doo Believe...bill.
I beleive that you can buy that bushing at Rex. They also have some newer designs but I am not sure if the bolt pattern are the same.
Mine is like yours and just didnt fit tight enough to seal. It leaked slowly all day. No big deal. I bought some liquid rubber in a can, the stuff they tell you to spray on tool handles for grip, and after a few coats of that stuff it seals up great now. All it did was make the outer diameter larger. And it still swivels ok in the metal housing. Just make sure to tape off the inside bore, you only want this rubber on the outside of the rubber ball.
Good Luck,
RandyH
Jesus Christ!!!! What did you seal that pump with ....spackle!!!!!!
No shit, pretty bad huh?
I had to do some emergency leak sealing in a freakin hot parking lot, so I wasnt' to oncerned about looks while I was baking my ass off. The pic was taken during my ro-do of the transom adaptor. Much cleaner look now.
OK, according to CP performance, this is not a Berk part.
Does anyone know what kind of steering Ultra uses, or used for an '01 21 XS?
I was just giving you crap!!!!!!
I was just giving you crap!!!!!!
Jeeezzz...I mean, the guy was bleedin! LOL!
I was just giving you crap!!!!!!
OK, according to CP performance, this is not a Berk part.
Does anyone know what kind of steering Ultra uses, or used for an '01 21 XS?
Might be an American Turbine steering tube. Rex carries em
http://www.rexmar.com/images/page120.jpg
Chris