oil puke tank needed!!!!!!

[TJS]

SuperDave,
I looked at your page for the weld in bungs. I am assuming the ones listed are all aluminum, correct ?? Good prices man. What I did for my tank was get a regular NPT to -10 and then turn off the NPT end on the lathe. I welded it from the inside for a cleaner look. The next one I build I will look you up.
Thanks.
T.J.
396- I sent you a PM.

[superdave013]

SuperDave,
I looked at your page for the weld in bungs. I am assuming the ones listed are all aluminum, correct ?? Good prices man. What I did for my tank was get a regular NPT to -10 and then turn off the NPT end on the lathe. I welded it from the inside for a cleaner look. The next one I build I will look you up.
Thanks.
T.J.
396- I sent you a PM.
Yes they are. And the do not have a hex flange. I thought the round flange looked better and would be easier to weld. Also they have a small locating delio on the back side so they stay put when you start to weld on them.

[Taylorman]

Here is what I run.
http://www.jegs.com/photos/026ACBT.jpg
Does the job!
HBjet
You have this on one side or both?
How do you guys mount the Rex puke tanks? What are the mounted to?