Well I have been having some problems and am gonna try to water again
this evening. Thought I would see what opinions I get from this wealth of
knowledge here on the forums.
I had an issue with lack of water and cracked a set of Gil offshore manifolds and let a little water in the oil. tore down the engine and all looked good. Called lightening and had a custom set made to clear the
Quad Rotor Whipple set up and installed.
Went to go test and the boat would not accelerate and never did get on plane.. hooked up my laptop and tried like hell (5 hours in the water) boat would always start and idle/acc in nuetral. Put it in gear and idle out of the 5 and would never even get a few hundred rrr's. The next week tried again and had to give 200% more fuel than normal to get the boat on plane and so on to get more rr's.. Ran for about 15 minutes and re-mapped up to 4k rpms's and 85mph.. Then shut down and when restarted it was back to shit again.
I found low voltage,and a bad abttery so I had my alt. rebuilt.. Also ordered and installed a new map sensor..
Any thoughts on what to look for tonight????
Getting really frustrated with this shit...
Racer52