You check clearance between the lip of the impeller and the wear ring. no tighter than .025. The 2 pieces of hose seal the steering tube at transom. Budlight
I'm rebuilding my JE pump and was wondering where do you check the tolerances and what should they be for the impeller. The kit came with shims.
I have two rubber hose pieces left that I don't know where they go.
Ones 3/4"by 1" long and the other one is 3/8" by 1/2 long.
You check clearance between the lip of the impeller and the wear ring. no tighter than .025. The 2 pieces of hose seal the steering tube at transom. Budlight
I have two rubber hose pieces left that I don't know where they go.
Ones 3/4"by 1" long and the other one is 3/8" by 1/2 long.
With a JE pump you wont need either of those hoses. For a JC or JG they would be the steering tube seal and the reverse cable seal, respectively.
Thanks for the info guys.