I am building a motor for my 1975 18' Southwind with a Berkeley 12JC-A pump that has been reworked a little by Tom Papp. I need help picking the rest of the parts needed to complete this project. i am still unshur what fuel delivery system i want to use it is a toss up between a tunnel ram with duel carbs or a Enderle mechanical Fuel Injected tunnel ram (BIRDCATCHER INJECTOR TUNNEL RAM) has anyone run this type of intake if so how did it work out? I am also looking for a good Ford engine builder.I have made a list of the parts I have already and a list of parts i still need to get. any help recommending manufacturers or part #s would be of great help I seem to get confused when it comes to the valvetrain.
parts I have
Scat 4.15 crank
SCAT H-Beam rods
SRP pistons 10.3:1
Sealed-Power rings
ARP main studs
ARP Head studs
Clevite 77 "H" series main bearings
Clevite 77 "H" series Rod bearings
Clevite 77 cam bearings
Cloyes Billet true roller timing set 9 Keyway
Blue thunder heads 74cc with 2.25,1.88 std HT. ford exhaust
Bassett 10 Quart oil pan W/ windage tray
Bassett water injected headers
parts I need
roller rockers what ratio ?
Cam hyd. roller prefered
hyd roller lifters
oil pump
distributor
gasket set
push rods
valve springs
valve spring retainers and locks