What size it?
Left over from sale of cat..perfect in the box condition..not labbed. stock.used for approximately 20hrs,cant use on new boat..fits bravo one drive..cost 275.00..I will pay shipping.
Sorry...its a 28...15.5 diameter..stock part from Hydromotive......
[ October 11, 2002, 03:11 PM: Message edited by: hpron ]
What size it?
Sorry about that..see edited post..
Is that the intimidator series? Also, are there any dings or damage? Do you have any pics? What kind of boat/engine did you have it running on?
I am currently running a 30" Bravo 1, and would like to see if I can more RPM's with a 28".
mbrown2:
Is that the intimidator series? Also, are there any dings or damage? Do you have any pics? What kind of boat/engine did you have it running on?
Icurrentlyam running a 30" Bravo 1, and would like to see if I can more RPM's with a 28".I was running this on a 22ft Talon cat with stock carb hp500..had a 30 pitch on it and needed to get closer to rev limit..brought rpm's right up there..never bumped it.. I ran the 30 hydro on it until it got to humid and hot..then put the 28 on and BANG,,dont have any pic..but it is perfect..no nicks or anything..I only ran it about four times before I sold the boat..I was going to send it back and let them tune it,lab it etc..but didnt get to keep the cat to do it..yes it is the intiminator series quad IV..it made the Talon handle awesome..very very snappy...gps several times at 88--90
HPron...you have a PM
mbrown2:
HPron...you have a PMI returned your pm..Ron...I will cover ups cost..
[ October 13, 2002, 05:05 AM: Message edited by: hpron ]