dominator adapter

[keithmenard]

I am putting my turbo engine back together...I went to aluminum heads, and was given a team G manifold.
My intercooler has a standard holly bolt pattern...if I put a 2inch adapter on it looks like its 5 feet in the air.
Are there any smaller adapters out there, or any one doing some one offs that wouldn't break the bank?
thanks guys!

[obnoxious001]

It may be simpler to use a different intake, or you can pull your intercooler apart and have someone machine it out and weld an adapter straight on to it. What type of turbo system are you working with, and what level of performance are you trying to achieve?

[Badburn]

I have some adapters on top of my 8-71 Weiand blower that adapt from standard holley to dominator carbs. I believe they are a weiand part and are about an inch thick. They use carb studs that are bent from one pattern to the other. Check with Holley(weiand).

[wsuwrhr]

Ebay the team G and buy the right manifold.
Brian

[superdave013]

I will make you a 1" thick one off deal for 100 bucks.

[wsuwrhr]

I will make you a 1" thick one off deal for 100 bucks.
I have several in stock....200 hundred bucks.
Brian

[superdave013]

Well I guess you one upped me Brian. I don't have any in stock but I do have a nice chunk of 1" 6061 sitting there. lol
Also have a mill or three.
Lots of bling at the sand show. Did you go? I didn't have a booth but one of my customers had our stuff in a nice display.
http://www2.***boat.com/image_center.../9DSC01865.JPG

[wsuwrhr]

Well I guess you one upped me Brian. I don't have any in stock but I do have a nice chunk of 1" 6061 sitting there. lol
Also have a mill or three.
Lots of bling at the sand show. Did you go? I didn't have a booth but one of my customers had our stuff in a nice display.
Cool shop. I did go on Saturday for a few hours. Had my billet Banshee cases on display. I saw my custumers and met a few new ones.
Had to get back and make chips since the mill is running again.
Brian

[keithmenard]

I am going to explore the changing the flange on the intercooler route.
I will let you guys know how I make out.
here are a couple pics so far:
http://static.flickr.com/32/44073136_c2fd97e167.jpg?v=0
http://static.flickr.com/31/44072989_534f658ff6.jpg?v=0