Problems re-starting 460 in my Kachina....

[Yarder]

After runs of differing lengths on my last few trips...
Any ideas what could cause this...

[Mighty Thor]

Yeah, something is not working right.
Seriously, more info is needed. does the engine turn over? does it have a fuel or spark problem, did you have any problems on any of the runs?

[Squirtin Thunder]

I am tell you it is the canutor valve !!!
Or too much timing !!!
Dose it sound like this;
rauh rauh rauh rauh rauh, then it fires barely right ???

[Mighty Thor]

I am tell you it is the canutor valve !!!
Or too much timing !!!
Dose it sound like this;
rauh rauh rauh rauh rauh, then it fires barely right ???
Damn it stop that! :hammerhea

[SmokinLowriderSS]

No, no, no, no! It's definitely not the canuder valve.
Sounds like a mufler bearing getting tight, just beginning stages of a seizure.
:idea:

[rerfert]

How about this one...torque the lug nuts on the trailer
seriously, more info needed
check for a bad ground??
too much paint on some mating surface causing a bad ground?

[Moneypitt]

Pull the long bolts out of the end cover of the starter. Look at the bushing, is it worn oval on the bottom? If so, turn it 180 degrees, now the lower side is not worn and the starter armature won't drag on the field windings. If this cures it, you're not done, go get a starter at your earliest convience.......MP
I think fords have those long bolts?? Either way check the brush end bushing

[Yarder]

ok ok so i'm a silly noob...I checked the muffler bering and it is missing as per the owners manual that came with the boat...riiiight... and the canutor valve is within specs..
No problems on the runs usual stuff up and down river, just wont crank over when "hot"...
I will check grounds and other electrical connections but it only happens after running around for a bit..
I admit I am not a motor guy but some help on where to look would be nice
:yuk:

[Squirtin Thunder]

ok ok so i'm a silly noob...I checked the muffler bering and it is missing as per the owners manual that came with the boat...riiiight... and the canutor valve is within specs..
No problems on the runs usual stuff up and down river, just wont crank over when "hot"...
I will check grounds and other electrical connections but it only happens after running around for a bit..
I admit I am not a motor guy but some help on where to look would be nice
:yuk:
Dose it sound like this;
rauh rauh rauh rauh rauh, then it fires barely right ???
Too much timing !!!

[Yarder]

thanks Squirtin, sometimes it does the rauh rauh rauh.... sometimes nothing, like starter cant turn motor...
If too much timing how can I fix it...or should I see a professional..?