Hello everyone, I am knew to the ***boat boards but not new to boating. I am currently trying to find on of the 21ft aluminum tunnel hull jets to build a hotrod/family boat out of that I am wanting to build a twin turbo motor for. This will be my first twin turbo deal but I have run blowers for years. I am wanting to go against the grain and do this thing with some type of EFI injection setup even though all the car guys are saying it won't work. Do any of you have experience with this type set up in a boat running sensors? If so would you care to share your thoughts.
Here is a small parts list of what my base build will be:
1. Donovan Marine anodized aluminum block 4.625" bore
2. Sonny Bryant crank 4.25" stroke
3. Steve Schmidt Pro-Filer 12 degree heads w/ 2.400int 1.880ext
These are the parts I have to start with. I am also thinking about running GRP aluminum rods but I am not sure about longevity in a recreational boat.