Check pm's Mark.
I am selling my Dan Olson oil pan ... set up for external pump (single stage). Jet or I/O drive for a BBC.
Windage tray, tig welded ... perfect condition, etc, etc, etc
$450
http://www.***boat.com/image_center/..._07_06_003.jpg
http://www.***boat.com/image_center/..._07_06_004.jpg
http://www.***boat.com/image_center/..._07_06_005.jpg
Also have 2 BBC short deck 4 bolt main blocks, std bore on both, neither have been hurt ... ones a short block w/ crank rods and all (but needs to be gone through) the other was going to be my personal block ... to I've polsihed/deburred the lifter galley and cleaned up the oil return passages, started another race project ... so these will just be sitting here collecting dust.
$500 each (firm)
Check pm's Mark.
Yeah....Check your pm's Mark! :crossx:
would that work on something with a 4.75 stroke? couldn't hurt to ask....:idea:
Check pm's Mark.
I just called you Mark.:hammer2: LOL. I knew a guy named Mark Busby. Sorry Brian.
would that work on something with a 4.75 stroke? couldn't hurt to ask....:idea:
No 4.5 is the biggest stroke the pan will allow ... I spoke to Brian Olson though and the rails can be notched :idea:
Jerry ... not sure of the condition of the internals of the short block ... I would go through it ... not sure if it's cast or forged. It was a good block, that's all I cared about.
Ross ... swing by the shop to check out the blocks anytime.
BB