Reply With Quote25k, i dont think so!
http://cgi.ebay.com/ebaymotors/ws/eb...3artq%3aus%3a1
I emailed this guy and he says it will go 130 mph with the right fuel and the motor turns 7000+rpm with a 3AAA impeller
25k, i dont think so!
$25,000 and you get the woodgrain dash
man oh man! Since an A Berk takes almost 1100 HP, and an AA berk needs a bit over 1300 HP to spin 7K, I'm guessing an AAA would take just shy of 1600 HP to make 7grand. One hell of an NA Tunnel Ram motor he has there! WOO WOOO!!!
Some of you blower guys need a lesson from this guy's engine builder on how to make REAL HP. NA and 3HP /CID.
the right fuel is liquid oxygen and jet A... downhill of course!
the right fuel is liquid oxygen and jet A... downhill of course!
Nah- it's got to be the "teflon coated" pistons and titanium valves!I mean- that's got to be good for 500 horses right there, dontcha think?
Nah- it's got to be the "teflon coated" pistons and titanium valves!
MAN I GOT COATED PISTONS TOO, I GOTTA BE DOIN 130 THEN,GPS HAS GOT TO BE WRONG! DAMN TECHNOLOGY!
I have heard of an A, 2A, 3A and even a 4A but what is a 3AAA impeller, is that equivalent to a berkeley 6A? That could be the reason for the 130 MPH speeds
I think this guy has nitrous,being piped into his mouth,Or he's sucking on exhuast fumes. Hey wait I think I have a 20,000 dollar boat sitting in the back yard any takers? it says bayliner on the side!
This is copied from his ebay description "Motor description is as follows, a 519 cid with only 10 hrs on it, has steel rods and crank, seal power pop-up pistons with teflon coated skirts, full roller cam, 578 lift with 290 duration, roller lifters and rockers. 7 1/16ths push rods with guide plates"
*519 cubic inches, what combination is that
*578/290 lift roller cam, with the small lift I doubt the duration number is @ 0.50, seems a bit small to be a roller
*7 1/16 push rods, maybe he means 7/16 pushrods but those seem out of place with the cam he has listed
Posting Permissions