more progress pics

[steelcomp]

for those of you who have been following my project, here's where it's at as of tonight. It's finally coming together.
Here's a mock-up of the transom adapter, pump and steering (with exception of that droop...I'll be changing that) This was last weekend.
http://www.***boat.com/image_center/..._1054_0001.jpg
http://www.***boat.com/image_center/..._1052_0001.jpg
http://www.***boat.com/image_center/..._1047_0001.jpg

[steelcomp]

This is as of tonight. The transom adapter, suction, pump braces, tunnel plates,etc. are done, instaled, sealed...permanento. Impellers are installed, clearanced, ready to go. Still waiting on the "droop", then I can finish the steering.
http://www.***boat.com/image_center/..._1075_0003.jpg
http://www.***boat.com/image_center/..._1085_0001.jpg
http://www.***boat.com/image_center/..._1080_0003.jpg

[steelcomp]

Here's what's going on inside. Jetaway installed, filled with oil, done. Fuel pump and lines installed, new rails mounted, other pump brace in progress.
http://www.***boat.com/image_center/..._1081_0003.jpg
http://www.***boat.com/image_center/..._1082_0003.jpg

[steelcomp]

I've got one seat installed for now, the Calgo is mounted, cables routed. Still need to mount the throttle and shift lever.
http://www.***boat.com/image_center/..._1083_0003.jpg
http://www.***boat.com/image_center/...29100_1060.jpg
Here's a close-up of the seat.
http://www.***boat.com/image_center/...29100_1058.jpg
So there it is. Shouldn't be long now. Looks like PT2 is a go.
Thanks for taking time to check it out.

[steelcomp]

That is looking focking great bud. But on to my noobie question. What is that billet looking piece on the front of the pump? And what exactly is a jetaway? Sorry to steal your thread No worries. That billet thing is the Jetaway, which is a ratcheting device that allows the pump to freewheel in case of an engine lock-up. It can also be used as a neutral for trailer running, and not spinning the pump.

[RCB19]

Looks pretty flawless Steely Dan. Did you ever get the battery mounting figured out? Again!!! Nice rigging job!

[MikeF]

Like'n that inside transom support plate. Looking forward to seeing what it will run!

[396_WAYS_TO_SPIT]

looking good scott What bowl is that? It looks like a dominator but not sure. What are you running for impeller??

[steelcomp]

looking good scott What bowl is that? It looks like a dominator but not sure. What are you running for impeller??Michael, yes, it's a Dominator. I'm running a B/C stainless with an inducer.
RCB19...thanks...I did get the battery thing worked out. Thanks again for the info.

[shaun]

Where'd you get your railkit from?
Hey, lets try to keep these pics at least 640x480... i want to see more detail