fuel lines

[beaverfab]

Just wanted to show you another way to do fuel lines. I was tired of braided lines so I did these hard lines. They were in the water for 3 years without any problems.
http://free.***boat.net/gallery/Read...s/Dcp_0018.JPG
[This message has been edited by beaverfab (edited July 13, 2002).]
[This message has been edited by beaverfab (edited July 13, 2002).]
[This message has been edited by beaverfab (edited July 13, 2002).]

[Thunderbutt]

Beaver, Have you run the motor yet. The line coming from the pump looks small for 2- double pumpers. What size is the motor? Originally posted by beaverfab:
Just wanted to show you another way to do fuel lines. I was tired of braided lines so I did these hard lines. They were in the water for 3 years without any problems.
http://free.***boat.net/gallery/Read...s/Dcp_0018.JPG
[This message has been edited by beaverfab (edited July 13, 2002).]
[This message has been edited by beaverfab (edited July 13, 2002).]
[This message has been edited by beaverfab (edited July 13, 2002).]

[Morg]

Beav,
Nice set up verry clean. I am also wondering about the size of the line coming from the fuel pump.
Morg.

[beaverfab]

Lines are 3/8", motor is mild 454. there is a filter in the line just after the pump 40 micron. Was in my cole flat ran 82/86 mph. Never had any problems.

[ssmike]

Beaver,
You make the whirl-a-way's, right? How much for a set for my superstock. It has a 10 degree casale box, I am a member of the CVDCOA.
Thanks
ssmike

[beaverfab]

I make prop shaft release, can not use that other name. The kit is $600. to members the dogs are $300. a set.If I can help let me know. j.j.

[Hotcrusader76]

How about letting me clean up those carburetors for you bro. Mill off the choke horns, freshen them up with Chrome and the TPC Racing goodies?
www.tpcracing.com (http://www.tpcracing.com)
Ty
tdlofstrom@tpcracing.com

[beaverfab]

Thanks but this motor is going on the stand for backup . New motor is injected. j.j.