WANTED: 396, rebuildable shortblock, right coast please...

[T-56]

Title pretty much covers it.
Worn slam out is fine. Block and crank should be machinable. It'll be bored big anyway and I don't mind running a .030/.030 crank since this will be a stock engine.
Wouldn't mind more than one.
Closer to SC the better.
Thanks for your time.
Robert
EDIT: Just a block (w/ main caps ) and a crank that I can buy for around $300 (ballpark, not looking for a freebee) and can drive to pick up and drive back to the house in less than 12 hrs.

[DansBlown73Nordic]

I have a std. 454 two bolt main block with a fresh turned forged 427 crank. New York State!!!

[Norseman]

I have a std. 454 two bolt main block with a fresh turned forged 427 crank. New York State!!!
Dan;
What are you asking for the block and crank. I've got a buddy looking for one to stick in a 66 Nova.
Does the block need any machine work, and are the bores already oversize?
Bob

[carreraboat]

i am in new mexico and have a standard bore standard crank and orginal heads for a 396

[T-56]

I have a std. 454 two bolt main block with a fresh turned forged 427 crank. New York State!!!
That would cost nearly as much to ship as it would to buy I'm afraid. :cry:

[T-56]

i am in new mexico and have a standard bore standard crank and orginal heads for a 396
If it's as nice as you're letting on, it's too nice for what I'm doing.
I don't mind putting a sleeve or 2 in one. God knows it wouldn't be the first time. :rollside: