I need a BLOWER...

[AngryJosh]

Its for a 440 Mopar.I need it to be complete with carbs, linkage, pulleys...
I prefer it to be polished, and ready to bolt on. Anybody have any leads?
Thanks

[Kindsvater Flat]

Here ya go. This is what it cost me.
http://www.schoutenranch.com/gallery...al_blower1.JPG
http://www.schoutenranch.com/gallery...lowersheet.JPG
It will look like this.
http://www.schoutenranch.com/miscboat/440/lines/33.JPG
And it didn't last long. :cry:

[wsuwrhr]

http://www.schoutenranch.com/gallery...al_blower1.JPG
It will look like this.
And it didn't last long. :cry:
Damn engine assemblers.
Brian

[wsuwrhr]

I have always seen new about 3500.00 complete.
KF looks like he got a pretty good deal, all polished too.
AJ, make sure you plan on BUILDING the motor for the boost you want to run also.
Cam, valvesprings, compression and piston/bearing clearances will need to be different.
Just trying to help a brother Mopar out.
Brian

[YeLLowBoaT]

You may want to check out www.racingjunk.com There are some deals there if you look.

[wsuwrhr]

Might try this with better response in gearheads or blower motors.
Brian

[a catered life]

I need a BLOWER
don't we all

[NautiTwins]

Its for a 440 Mopar.I need it to be complete with carbs, linkage, pulleys...
I prefer it to be polished, and ready to bolt on. Anybody have any leads?
Thanks
LMAO. That sure would look sweet on that boat of yours. Just make sure that it will float with the extra weight.

[KACHINA KEN]

LMAO. That sure would look sweet on that boat of yours. Just make sure that it will float with the extra weight.
DOH!

[NautiTwins]

DOH!
LOL. I was being serious. The boat already sits pretty low in the back. WIth the added weight, I would seriously think of moving the motor forward. Just my .02