Results 1 to 10 of 10

Thread: estimate to replace 2 pistons!

  1. #1
    mouzer
    Im not a outboard person but i have a chance to pick up a tunnel hull Daytona style w/a mercury 2.4 bridgeport, top 2 pistons need to be replaced. already sleeved ? no other motor work but 2 new pistons no damage otherwise, how much we lookin at!

  2. #2
    Tom Brown
    Why did those top two pistons go? Has that problem been fixed?
    I'd say you're looking at an expensive learning curve. That's my estimate.

  3. #3
    STV_Keith
    Carb or EFI? Might have an injector/carb problem that needs to be addressed.
    As far as costs go, you'll need to hone (most likely bore and hone) those two sleeves, two new pistons and ring sets. Are the rods ok? Gasket set.
    Should run:
    Bore/hone 2 cyls ~$300
    2 pistons/rings ~$500
    Gasket set ~$200
    If no other work is needed, and you do the labor yourself, add about $150 for shipping the block both ways to someone like Jim Ruck, plus shipping on the other parts.

  4. #4
    mach1alaska
    Its not my boat but I am familiar with it.
    The cyls are in good shape and they wont need bored just a hone.

  5. #5
    Warlockjer
    Why did those top two pistons go? Has that problem been fixed?
    I'd say you're looking at an expensive learning curve. That's my estimate.
    I think he has had quite a few expensive learning curves lately

  6. #6
    mouzer
    Im so upside down its not funny.i messed up badley!

  7. #7
    H2oracer
    If it's already been sleaved it may have had this problem before. If the motor stuck the pistons you may be looking at bent rods and even a bent crank.

  8. #8
    Warlockjer
    Hey Mike , you WILL rebound

  9. #9
    Greg_Moss
    I would think if the top 2 cylinders burnt that the problemis cooling not fuel. I would make sure the water pump is good and that the water passages are all clear.

  10. #10
    mouzer
    Hey Mike , you WILL rebound so sorry about your boat deal w/me but im glad you sold it! (sort of) ! i did'nt buy this outbourd it was just offerd to me at a good price fixed or broken! but i still have to sell one more boat to get my my money's ! to buy another boat thats ready to go !yours was the best deal out there. for a complete sanger bubbledeck !

Similar Threads

  1. hey all we need an estimate in Parker
    By MRS FLYIN VEE in forum Sandbar
    Replies: 25
    Last Post: 09-19-2007, 05:47 PM
  2. top speed estimate
    By condor tx 19 in forum Jet Boats
    Replies: 28
    Last Post: 07-12-2007, 07:53 PM
  3. MPH estimate question
    By jbone in forum Jet Boats
    Replies: 25
    Last Post: 01-30-2006, 07:20 PM
  4. HP estimate help on a 455
    By Drunk tank in forum Jet Boats
    Replies: 11
    Last Post: 02-10-2004, 03:13 PM
  5. how fast ?? can someone estimate for me???
    By quig in forum Bench Racers
    Replies: 14
    Last Post: 03-23-2002, 05:28 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •