Rail Kit....

[TRG]

dimentions of a BBC rail kit or any type of drawings?
any info will help out bitchenly!
P.S. Been drinkin', sorry!

[TRG]

8 views,...come on guys?

[BrendellaJet]

They are all different. If you have some old mounts(4 point) use those as a pattern. Or do it the hard way like I did and make em yourself. I started with some masonite and when I was satisfied with the fit I transfered it to aluminum. Lots of work. Save some time and buy Duanes kit... Its a good deal. Fit it your self...measure twice, cut once.

[TRG]

maybe i should have gotten a little deeper in discussion,... Im being a lazy ****! and besides masonite is used for skating a ramps! basically i am looking for some #'s on the bolt pattern on the block!...sorry for not being clear as crystal, but remember....im ****oed!
Thanks again!
Todd

[Duane HTP]

"basically i am looking for some #'s on the bolt pattern on the block!..."
What is it that you are asking here???? We don't understand your question??

[wsuwrhr]

maybe i should have gotten a little deeper in discussion,... Im being a lazy ****! and besides masonite is used for skating a ramps! basically i am looking for some #'s on the bolt pattern on the block!...sorry for not being clear as crystal, but remember....im ****oed!
Thanks again!
Todd
Contact the guy who knows how to build this stuff.

[bottom feeder]

Is this what you need??
http://www.***boat.com/image_center/...evy_plates.jpg
I have most all the blocks :idea: What wsuwrhr said

[wsuwrhr]

Is this what you need??
http://www.***boat.com/image_center/...evy_plates.jpg
I have most all the blocks :idea: What wsuwrhr said
Got a magnifying glass?
That print is worthless.

[LGCDEVIL]

I've got a piece of 3/8" plate with that I traced the plates on. Center punched the holes. You are welcome to it. Just replace the plate with another patern after you have made your plates.

[edog_103]

Is this what you need??
http://www.***boat.com/image_center/...evy_plates.jpg
I have most all the blocks :idea: What wsuwrhr said
I am helping Todd out on this. What we are going to do is take these hole locations and make a pattern to be cut on the Laser. We can come up with some pretty creative designs. Can you attach this picture as a DWG file or DXF?