There's quite a few that makes them but Painless has some cool ones!..
Painless! (http://www.painlessperformance.com/webcatalog.asp)
I think I've asked this before but...
Does anyone know where I can get an AL rocker switch plate cover?
The one I have is beat to shit. It has "Start, Mag, Fuel and Bilge etched above each switch. I saw one awhile ago in a catalog but can't remember which catalog. Or does someone know where I can get one fabbed? The plate would be easy but I don't know about the labeling.
There's quite a few that makes them but Painless has some cool ones!..
Painless! (http://www.painlessperformance.com/webcatalog.asp)
Thanks Art.
Those are close I'm probably going to have to have one made.
Have you tried these guys???..
Eddie Marine! (http://www.eddiemarine.com/Cart/cata...=Switch+Panels)
I made mine for pull switches, same idea, any trophy place can engrave whatever you would like on the plate after it is fabbed up, I had the pull knobs engraved for my specific functions. Turns out to be a fairly inexpensive way to gat a nice cutom set-up.
Good luck
John
Thanks Art. I'll see if Eddie M can make me one.
If not I'll have Baot anchor make one and follow LD Mandella's advice.
Or..................I'll see if a trophy shop can do the whole nine yards.
Boat Anchor makes nice stuff. Why buy the same thing everyone else has when you have his talent right there?
Boat Anchor makes nice stuff. Why buy the same thing everyone else has when you have his talent right there?
I was worried about the etching. I would talk to him first if I couldn't find one off the shelf (which I haven't). So I took LD's suggestion and will have Scott make me one and the trophy shop will etch it.
Thanks for all the input.