Yep, tall deck is .400 taller but you can make a spacer for it!..
So i have this Mallory Super Mag II i have had for awhile and was thinking about using it on my latest project. 468 tunnell ram motor, it had a MSD in it. So i pull it out an take a look at them side by side. The Mag is about a 1/2"-3/4" longer? What gives, is it for a tall deck?
Yep, tall deck is .400 taller but you can make a spacer for it!..
Compare location heights. There were low and tall deck tach drive bases also.
So is it worth running a spacer or just buy a box and run the MSD?
Run the mag, put a spacer on it, you can buy distributors with spacers to accommodate both deck heights!.. But like Bob says, compare locations!..
Thanks for the help, I'm not a machinest so can you buy a spacer and where? Never seen them advertised.
All they are is an adjustable collar, I'm sure MSD or Mallory has them or any HP distributor MFG???..
Thanks I'll check it out
This what you are talking about. http://store.summitracing.com/partde...5&autoview=sku
looks too easy?
Can't you just take a distributor gasket to a machine shop as a template and have them make a spacer out of .400 aluminum?