Leave it to Eliminator to build a 100k+ boat and put the drives in the wrong place....
I was prepping my engines to be pulled out for a spring rebuild when I started eyeballing the engines and sure enough one was noticeably lower then the other.. Thought one was out of alignment, but the engine alignment tool slide right in both holes just fine. So, then I took the ruler to the back of the boat and sure enough the port outdrive is 1/2 inch lower than the right.... That port engine always has seemed slugish compared to the other(always down by a few hundred rpms)...maybe now I know why....
Question is though...would a 1/2 actually cause that??
Thanks