I use Mid Valley in Burbank. What do you want anodized?... What kind of finish? Colored or clear? If it isn't polished it will come out quite dull.
anyone do it or know of a good place in so cal to get it done? i have some jet ski parts i need done. was wondering what this is gonna cost me.
I use Mid Valley in Burbank. What do you want anodized?... What kind of finish? Colored or clear? If it isn't polished it will come out quite dull.
I use these guys for work. Always good quality stuff.
Barry Avenue Plating
2210 Barry Avenue
West Los Angeles 90064
310-478-0078
Dunham in Orange did these. Matched the color really good. They do lots of boat parts also.
http://www.sweetperformance.com/phot...le_anodize.JPG
I use these guys for work. Always good quality stuff.
Barry Avenue Plating
2210 Barry Avenue
West Los Angeles 90064
310-478-0078
Oh yeah... they did some bright anodization on an Aston Grill for me ONCE... It was the shiniest anodization I've ever seen. But they charged me 360.00 for what mid valley will do for 40.00. You decide. Get comparative prices first.
Just a thought, I would never anodize a boat part again, only powdercoat. You may want to consider it, if its an option for your parts.
:dupe post:
Barry avenue is a very good plater, we used to use them alot but our connection down there retired about 4 or 5 years ago, we've been using Jenco Plating and had excellent results with them lately. Personally i think anodizing is far superior to powdercoat on aluminum parts, it will never chip or peel and will last forever with proper care, keep it waxed and it wont fade unless there is heat involved.
http://http://mail.1parkplace.com/at...2/Picture4.jpg
http://http://mail.1parkplace.com/at...6/Picture4.jpg
http://http://mail.1parkplace.com/at...4/Picture4.jpg
http://http://mail.1parkplace.com/at...7/Picture4.jpg
http://http://mail.1parkplace.com/at...5/Picture4.jpg
i will consider powder coating. im just afraid of it chipping or peeling. anyone have a ruff idea of what this would cost to do either?:hammer2:
ok ill try this.....