.............Sounds like you may have found a boat. If so post a pic if you can.........
I live in the midwest (Indiana) just wondering if anybody had a big block chevy for sale? ben_monjon_1964@yahoo.com. Thanks
.............Sounds like you may have found a boat. If so post a pic if you can.........
I have blown 468. $5000
http://minneapolis.craigslist.org/boa/252437974.html
This has been on a long time. One has been sold.
I have a rebuilt 454 in my motor home that has only 500 miles since the rebuild. I have change my plans and would part with it for 1850.00. E-mail me if your interested. (engine is still in the vehicle and running, Located in SW Missouri) ronruggles@cox.net
I live in the midwest (Indiana) just wondering if anybody had a big block chevy for sale? ben_monjon_1964@yahoo.com. ThanksWhat HP you looking for?
I'm just looking for something that runs good and looks pretty good. I don't need anything outrageous. 400-600 horsepower will be fine.
Thanks everyone
i have a blown gen VI fresh rebuild up for sale...i just baught boat and im putting in a BB CHEV STROKER. it will be up at jetboatperformance and you can talk to tom about it after he pulls it out.
$3500.00 obo
I'm just looking for something that runs good and looks pretty good. I don't need anything outrageous. 400-600 horsepower will be fine.
Thanks everyoneI would talk to Blown to the Bone here on the boards Rick hes got to have something lying around Rick you out there????
I have one you might just be interested in if so please call me at 814 395 0417 ask for seth. needs assembled if any one else wants it contact me. should make 506 hp an 517 torque according to dyno 2000
1981 chevy 454 block says high performance right on it. It is .30 over cylinders will need to be honed. (new cam bearing installed)
Kieth black pistons. Should be 10.1 compression with these heads
A set of 1971 oval port heads check the numbers. machined for 2.19 intake valves an 1.85 exhaust valves.
16 stainless valves 2.19 an 1.85 not undr cut or swirl finish just plain stainless
Eagel Crank what I have be told any way.
Chevy 2 oil pan
Not actul but what they are for 1st generation camaro headers
Iskendarian cam, lifters, an dual springs
SFI aproved fluid dampner
SFI aproved fly wheel
aluminum pulleys crank an water pump only
big endfuel pump block off plate
Weiand team G aluminum water pump
Pete Jackson Gear drive " Dua Idler" camshaft drive
Edel brock "street master" intake
Harland sharp Aluminum Full roller rocker arms " friction free design Gives 15-40 hp"
Hamburg mini starter high torque
Mallory 140 gpm fuel pump
Mallory fuel pressure regulator
8 Chevy reconitioned rods an hardend studs
ARP screw in rocker arm stud kit
Mr.Gasket exhaust gaskets
Timing cover with indicator
Holley 780 carb I will though in Not sure what model
an a set of crome valve pan covers
this is everything you will get
an only asking $4500 or best offer.