prop puller

[Fired Up]

Looking for a prop puller to pull the prop on my canyon flat. 1 1/8 shaft, 11 1/8 x 16 2 blade prop. Anyone have a good source. This is my second post. Not sure where my first one went?

[schiada96]

Rex marine, Eddie marine, You can make your own also.

[sgdiv7]

I made mine from a photo I saw on the Glen-L marine web site. Cost me like $10.00 to make.they sell them and CP Performance does also.
Bill

[Stab-n-Steer]

F-up,
If you are into "trick" tools OJ props has the nicest "looking" set I've seen. Go to http://www.ojprops.com/proppuller.html
[This message has been edited by Stab-n-Steer (edited November 29, 2001).]

[spectras only]

Fired Up,you can purchase the puller from california marine [604-278 1880] for 51.75 Us+shipping.

[DetroitJim]

I have one that I ordered from Glenwood Marine. It is a massive hunk of bronze, very stout. It was a lot, 80-90 bucks I think but worth it.

[Fired Up]

Thanks guys,
Picked up the OJ prop puller. Did the job!