Page 1 of 3 123 LastLast
Results 1 to 10 of 25

Thread: Big Proppa...

  1. #1
    Sangster
    How's the boat coming along..Got Boat, Got Water,Got Pics???

  2. #2
    Big Proppa
    Well actually I only have a few things left - I'll be changing gears tomorrow, installing my fuel tank on Saturday and hopefully if I have enough money left I'll be plumbing it on Sunday. My goal is to be 100% by the run what ya brung event and as of right now I think I'll make it.
    Will you guys be coming down for that one?.

  3. #3
    GofastRacer
    Big Proppa:
    Well actually I only have a few things left - I'll be changing gears tomorrow, installing my fuel tank on Saturday and hopefully if I have enough money left I'll be plumbing it on Sunday. My goal is to be 100% by the run what ya brung event and as of right now I think I'll make it.
    Will you guys be coming down for that one?. Check your E-Mail please!. wink

  4. #4
    Big Proppa
    Hey sangster - mounted the fuel tank, installed my seat and changed the gears so far this weekend,hopefully tomorrow I'll have a chance to plumb it and clean it up and thats about it other than the splash guard.
    I have update photos that I'll post sometime tomorrow.

  5. #5
    Big Proppa
    here are a few photos of the fuel cell mounting brackets we made, fuel tank originally was wider than the back of the boat so we had to cut the bottom tank down and re-fab the mounting brackets
    Original Bracket
    [img]http://www.***boat.net/image_center/data/500/16MVC-609F-med.JPG[/img]
    And after
    [img]http://www.***boat.net/image_center/data/500/16MVC-613F-med.JPG[/img]
    The tanks were still wider than the stringers so we had to kick the mounting bracket over to compensate.
    [img]http://www.***boat.net/image_center/data/500/16MVC-612F-med.JPG[/img]
    [img]http://www.***boat.net/image_center/data/500/16MVC-610F-med.JPG[/img]
    here is the tank cut down
    [img]http://www.***boat.net/image_center/data/500/16MVC-615F-med.JPG[/img]
    New seat
    [img]http://www.***boat.net/image_center/data/500/16MVC-617F-med.JPG[/img]
    final shot of the tanks installed -
    [img]http://www.***boat.net/image_center/data/500/16MVC-614F-med.JPG[/img]
    I went with the doubles because of all the cruisen around we do - I'm sure I gave up a few mph - but atleast I wont have to stop for gas every 1/2 hour
    off to plumb it -

  6. #6
    GofastRacer
    Big Proppa:
    Hey sangster - mounted the fuel tank, installed my seat and changed the gears so far this weekend,hopefully tomorrow I'll have a chance to plumb it and clean it up and thats about it other than the splash guard.
    I have update photos that I'll post sometime tomorrow. Check your PM please!!..

  7. #7
    wfodude
    Big proppa check your pm's

  8. #8
    77charger
    looks good bill but is that motor a top secret project since you have it covered?

  9. #9
    Big Proppa
    no 77 - I wish it was though! - carbs are off so I covered it

  10. #10
    Big Proppa
    OK got the fuel pump mounted to the fuel tank bracket had to space it out a little to miss the bracket leg
    [img]http://www.***boat.net/image_center/data/500/16MVC-618F-med.JPG[/img]
    [img]http://www.***boat.net/image_center/data/500/16MVC-623F-med.JPG[/img]
    hooked up most of the water lines but ran out of braided line -
    [img]http://www.***boat.net/image_center/data/500/16MVC-622F-med.JPG[/img]
    wow the floor in my jet boat was never this clean
    [img]http://www.***boat.net/image_center/data/500/16MVC-621F-med.JPG[/img]
    [ February 23, 2003, 06:14 PM: Message edited by: Big Proppa ]

Page 1 of 3 123 LastLast

Similar Threads

  1. Thanks Big Proppa!!!
    By Heatseeker in forum Jet Boats
    Replies: 13
    Last Post: 11-01-2004, 06:45 PM
  2. Big Proppa says....
    By Kindsvater Flat in forum Jet Boats
    Replies: 25
    Last Post: 10-12-2004, 01:33 PM
  3. proppa update
    By gunslinger in forum Jet Boats
    Replies: 3
    Last Post: 06-14-2004, 10:42 AM
  4. Big Proppa: Thanks!
    By Heatseeker in forum Jet Boats
    Replies: 19
    Last Post: 04-07-2004, 06:49 AM
  5. Hey Big proppa
    By Infomaniac in forum Gear Heads
    Replies: 6
    Last Post: 09-09-2003, 07:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •