Reply With QuoteMine all work fine. :idea:
After the rough water on Havasu this past saturday half way back from Moabi the oil pressure gauge would hover and then flat line. It did this quite a few times on the run back to cattail.
Loose wire?
Bad ground?
Sending unit?
Anybody else have a crappy OP gauge?:idea:
Thanks!!
Mine all work fine. :idea:
After the rough water on Havasu this past saturday half way back from Moabi the oil pressure gauge would hover and then flat line. It did this quite a few times on the run back to cattail.
Loose wire?
Bad ground?
Sending unit?
Anybody else have a crappy OP gauge?:idea:
Thanks!!
:jawdrop: :jawdrop: :jawdrop: :jawdrop: And they wondered why I like to keep my motor under 3500 RPM's.
I have modernday electronics that would buzz if there was a problem
Anybody that dosen't have an old ass 80's boat have info?:devil:
I have modernday electronics that would buzz if there was a problem
Anybody that dosen't have an old ass 80's boat have info?:devil:
Doesn't that fancy new boat of yours have a warranty?
Doesn't that fancy new boat of yours have a warranty?
2yrs is up
All maintanence has been performed and the boat only has 90 hours
I have modernday electronics that would buzz if there was a problem
Anybody that dosen't have an old ass 80's boat have info?:devil:
My boat would buzz too.....I dont even have an oil pressure guage to worry about
Mines about 15years newer than the 80's....d JUNK e's boat on the other hand belongs in some museum somewhere
We had a bad ground in the jetboat and the gauge quit altogether, so if it's still trying to work I would check to make sure all the wires have a good connection.
Ok in all honesty here (I know hard to believe) I'd start checking the wires behind the gauge to see if somethings come loose. Next since your mechanically inclined you might wanna take the gauge out and either test it yourself or take it to someone to have it tested. I'd explain how to do it but I'm too lazy to type it out.
Posting Permissions