I have a Dominator pump and bowl with a A+ cut Stainless impeller , spinning right around 6100 ( no Inducer ) 3" nozzle insert
It has been mentioned I should send it off to be thinned and polished along with the bowl ( blueprinting ? the vanes )
and swapping my droop for a straight race nozzle
What kind of rpm gains - mph should one expect from this type work ??
Also who would you guys recommend ?
What does the work usually cost?
Thanks !
Gopher
get ahold of gary snow, he's close to ya and he'll take care of ya.cutting and detailing the impellor will make it faster, but you may sacrifice alittle holeshot for the mph.