Results 1 to 2 of 2

Thread: Alky

  1. #1
    novaz
    my new 383sbc is 8.5comp stage 2 6-71 running 10# boost
    forged crank and pistons with a solid roller 268/276 with .645" lift if i need more ummmph would running Alky give me more of an increase than say a 250 nitrous shot .
    I know that there would be different carb and timing requirements
    are there any good sites /pages where I can read up on this stuff
    would like to get some knowledge on this before going there
    2800# Nova
    Thanks
    Royz

  2. #2
    Kurtis500
    my new 383sbc is 8.5comp stage 2 6-71 running 10# boost
    forged crank and pistons with a solid roller 268/276 with .645" lift if i need more ummmph would running Alky give me more of an increase than say a 250 nitrous shot .
    I know that there would be different carb and timing requirements
    are there any good sites /pages where I can read up on this stuff
    would like to get some knowledge on this before going there
    2800# Nova
    Thanks
    Royz
    I guessing from a few details in your post that carbs are your induction. Alcohol will not give you the advantage over gas and an NOS shot at that compression ratio. If you stepped up the ratio (and boost)the alcohol should pass the gas/NOS level. And, you dont have to worry as much about bad timing/fuel distribution as you do with a NOS system which causes a melt down in no time. Alcohol is a little more forgiving on a missed tune-up. You will use a lot more fuel with alcohol. Try the HRE forums for some info.

Similar Threads

  1. Will this work for alky?
    By Blown 472 in forum Gear Heads
    Replies: 15
    Last Post: 05-23-2007, 05:18 AM
  2. Blown gas or alky which is
    By Blown 472 in forum Gear Heads
    Replies: 16
    Last Post: 01-14-2006, 03:14 PM
  3. V6 blown on alky???
    By Blown 472 in forum Gear Heads
    Replies: 7
    Last Post: 05-03-2005, 05:08 PM
  4. EFI and alky
    By Blown 472 in forum Gear Heads
    Replies: 4
    Last Post: 02-07-2005, 03:23 PM
  5. Nitrous and Alky
    By Max_182 in forum Bench Racers
    Replies: 4
    Last Post: 05-21-2003, 05:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •