Change the oil
ok, so i pulled the motor to repair/replace mounts, and figure I will re wire since my wires are getting britle, a little cleaning and painting, (first time motor has ever been out) Am I missing any obvious "should-dos" while its out?
considering doing something to the bilge area, any ideas?
Change the oil
Change the oil
maybe even the filter
maybe even the filter
Or just the filter then add a qt.
install drain plug extention.
check stringers for rot around the bolt holes.
take it down to the machine shop for a blower or turbos.
install drain plug extention. = done
check stringers for rot around the bolt holes.= doin tommorow
take it down to the machine shop for a blower or turbos. = need one of your stolen credit card numbers:devil: