4.155 bore Dart Big Bore 9.5 deck block with billet mains (2.75 cleveland main bearing) , Clevite Race Bearings, 30 axis machining, custom oil work and blue printing, machined for Danny B or Jesel Belt drive ( can also run stock style chain ), Bennett Scat crank Zero Balance, Scat rods and Ross custom pistons -15cc dish set up for TFS R heads and a max intake valve diameter of 2.10. its compression is 11.2:1 with a 67 cc. chamber for pump gas. Its brand new in the plastic container from Bennett and I have all the reciepts and build sheet for the motor along with head studs. New Cometic Head gaskets .040 thick and brand new set of fully ported TFS R heads setup for this motor with 2.10 intake valve and custom chambers all custom work done to the heads, PSI Springs for solid roller, titanium retainers, etc.
$8700 for all
** WILL NOT SEPARATE HEADS FROM SHORT BLOCK UNLESS HEADS SELL FIRST **
http://img503.imageshack.us/img503/6...7180011zc8.jpg (http://imageshack.us)
http://img396.imageshack.us/img396/9...7180010oe8.jpg (http://imageshack.us)
http://img401.imageshack.us/img401/4...7180009zp3.jpg (http://imageshack.us)
http://img396.imageshack.us/img396/5...7180007kp1.jpg (http://imageshack.us)
http://img396.imageshack.us/img396/5...7180008wc6.jpg (http://imageshack.us)
mvb93@aol.com
708 769 6364
Super Victor, custom porting with custom sheet metal elbow, fuel rails and lines custom matched to go with these heads $1000.
Thanks,
Mike