I'd say oh i don't know,..........maybe a 9/16 drill bit.
I want to put a key switch ignition in my 76 sanger....what is the best way to make about a 9/16 hole?
I'd say oh i don't know,..........maybe a 9/16 drill bit.
Tape the area to be drilled both front and back... mark where you want your hole, take your time and don't force it.
well I've just have never done this before and didn't want to crack the fiberglass.....i figured it was smarter to ask now, than to ask how to fix a cracked dash
A drill bit will FK everything up tape or not, use a hole saw makes a clean cut!...
the best way is to do it in steps start out with a pilot hole in the area of 3/16th then use a hole saw but make sure u go very slow untill u get into the wood then u can add a little preasure. also a trick i have seen is clamp a 1 by 4 on the outside then do the drilling. good luck
I have also heard it is good to run the hole-saw backwards to start the hole and then run it forward once the initial line is formed. Supposedly this works with upholstery and 'glass. I personally haven't tried it yet.
I want to put a key switch ignition in my 76 sanger....what is the best way to make about a 9/16 hole?
Great question, and look at all of the Different and approprite ways to accomplish that task! I love this forum!
the best way is to do it in steps start out with a pilot hole in the area of 3/16th then use a hole saw but make sure u go very slow untill u get into the wood then u can add a little preasure. also a trick i have seen is clamp a 1 by 4 on the outside then do the drilling. good luck
A hole saw has a pilot drill bit, just tape it and bore it done deal it's a no brainer!..
Hmmm, I don't think a few thousand's will matter too much for an ignition switch!...