3m 4200 fast cure.
Now the more mosture the stuff sees the faster it will cure. So after it is all set and done spray it down with water from a mist bottle.
Yea getting closer, Im out at 7am.
the silicone on the loader deal is a hassel. I dont silicone mine cause Im always taking them in and out but if your going to leave it in, its a good idea.
speaking of loaders....
bilge pumps........
3m 4200 fast cure.
Now the more mosture the stuff sees the faster it will cure. So after it is all set and done spray it down with water from a mist bottle.
This will be the 3rd time sealing the loader (holes). 1st time was my mistake, (I was very tired, trying to finish a bunch at 1am before vacation) used caulking that had silicone, that didn't take but 15min to blow that out. Through bolted with washers and lock nuts. Tightened with screwdriver and wrench. The 2nd time, I used clear silicone on the bolts, bolt holes and thin amount between plate hull. Because the 1st time, when it blew the caulking out, the loader was loose, so this time I used the 3/8 impact and a screwdriver bit, with a wrench at the other end. Drew up nice, sealed considerably better, but I couldn't leave the boat in the water overnight. I'm kinda tired of jackin with it. So I did pick up some 3m 5200, but they didn't have fast cure, so I'm hoping that 5200 slow, will at least seal.