Results 1 to 2 of 2

Thread: Rear bushing clearance

  1. #1
    Have my pump out (dominator) and it seems my rear bushing has a little slop in it. I can actually feel a little slop in it by pulling hard laterally on the shaft. Anyone know what the max clearance is? I pulled the bowl off and my shaft is 1.121-1.123 depending on where I measure it and the bushing measures 1.128-1.129. No lateral or fwd/back motion in thrust bearing. Any advice is appreciated. Tim

  2. #2
    it should not have any lateral movement. sounds like its time for a rebuild.

Similar Threads

  1. Starter Bushing gone bad
    By Nubbs in forum Jet Boats
    Replies: 1
    Last Post: 05-23-2006, 03:00 PM
  2. Starter bushing gone bad
    By Nubbs in forum Gear Heads
    Replies: 4
    Last Post: 05-23-2006, 07:28 AM
  3. Bushing melt
    By Fired Up in forum V-Drives
    Replies: 7
    Last Post: 04-26-2006, 07:02 AM
  4. Replies: 0
    Last Post: 08-29-2005, 12:25 AM
  5. strut bushing
    By meaniam in forum V-Drives
    Replies: 9
    Last Post: 06-09-2005, 11:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts