I put on a Hays 10-130 Billet Flywheel The stock cast one I was running before is about .250 Thicker. The stock one sticks out from crank 6" to where drive plate bolts. New billet is 5 3/4" You might see where this is going...My spline spacer is now approx .250 too short...Here is a pic. Sorry for the clarity, it was from my phone holding under tranny bellhousing...This was with spline mated up inside tranny all the way in properly and tranny bellhousing flat against motor plate...
And oh by the way ended up running the ARP pro bolts with red loctite as suggested...Thanks for the input...
Should I just have someone make a longer spacer to compensate the gap?
http://www.***boat.com/image_center/...ine_Spacer.jpg