Results 1 to 5 of 5

Thread: Pump Setup

  1. #1
    BrendellaJet
    Putting pump together. Nothing has been torqued yet, but bearing cap and impeller nut have all been snugged. With no shims Im seeing .062" clearance to the wear ring. From everything I've read this is too much.
    Wear ring was installed by MPD so I know its done right. is it adviseable to turn the shaft down ~.040 so I can throw a shim in it to get closer to .030? Impeller is a brand new Heritage Bronze...
    Thanks in advance for any insight.

  2. #2
    WishIknew
    Vacation Dude been at moabi 9days now

  3. #3
    hotbo
    turn the cone down on the impeller to make the difference up done it a dozen times.

  4. #4
    BrendellaJet
    Dont want to mess with the impeller. Talked to Jack, he said its common to have to trim the shaft. Got it done(thanks Pop).

  5. #5
    v-drive
    No problemo..pop

Similar Threads

  1. Magnaflow pump setup for $$$
    By Krumbsnatcher in forum Parts 4 Sale
    Replies: 3
    Last Post: 03-21-2006, 06:13 PM
  2. Cam Drive Pump Setup 4 Sale $$$
    By Krumbsnatcher in forum Gear Heads
    Replies: 0
    Last Post: 03-17-2006, 07:08 AM
  3. Spectra 20, Howard 21, etc pump setup
    By flat broke in forum Jet Boats
    Replies: 23
    Last Post: 01-25-2005, 05:51 PM
  4. Serious question about pump setup.
    By Jetdriver in forum Jet Boats
    Replies: 11
    Last Post: 08-04-2004, 01:52 PM
  5. Bilge pump setup in tunnels/cats
    By HP350SC in forum Gear Heads
    Replies: 11
    Last Post: 03-28-2004, 08:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •