Results 1 to 3 of 3

Thread: EGT or AFR gauge and bung

  1. #1
    ghittner
    I have stainless marine manifolds and Exhaust which of course are wet. I need an AFR or EGT gauge and sender as well as a bung to weld in. Does anyone make the bung or should I just cut one out of stainless rod stock? Thanks. Any of these gauge manufacturers better than others? Thanks.

  2. #2
    Unchained
    I got the A/F ratio gauge and the bungs from Innovate Motorsports and it has worked well. They have a web site, www.tuneyourengine.com

  3. #3
    ghittner
    What about drilling and tapping into my Stainless Marine manifolds right at the bottom of a cylinder? There is enough meat there to accomplish that.

Similar Threads

  1. Monkey Bung
    By Jetboatguru in forum Bench Racers
    Replies: 46
    Last Post: 03-09-2007, 06:37 PM
  2. bung
    By SUI-CY-COLE DIMARCO in forum V-Drives
    Replies: 2
    Last Post: 07-31-2005, 05:45 PM
  3. WHAT'S UP BUNG
    By Playa Hata in forum Bench Racers
    Replies: 140
    Last Post: 11-26-2002, 06:32 PM
  4. hey bung bung
    By SUI-CY-COLE in forum V-Drives
    Replies: 8
    Last Post: 09-06-2002, 07:27 AM
  5. BUNG AND FLYTE....
    By SUI-CY-COLE in forum V-Drives
    Replies: 9
    Last Post: 09-06-2002, 07:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •